Difficulty
Moderate
Steps
8
Time Required
00:20:00
Ce tutoriel a été créé par la communauté
User contributed
Parts
-
-
To remove the collar, insert a screwdriver between the 2 parts of the collar and turn it 1/4 turn clockwise.
-
Pull the pipe upwards
-
-
-
Clean the rocker cover with a suitable product
-
Clean the inner protection plate
-
Compare gaskets before reassembly
-
There may be a more or less significant layer of yellowish material due to water infiltration, or more seriously to a passage of coolant in the oil. Hence the need to replace this seal.
-
-
-
Clean the seal face with a clean, lint-free cloth. Do not use any products, then oil the seal face
-
-
-
Reassemble the inner protection plate
-
If possible, also replace the sealing washer of the two M8 screws - 13 mm spanner.
-
Reinstall the rocker cover
-
Cancel: I did not complete this guide.
13 other people completed this guide.
9 Comments
I broke a screw on the rocker cover when reassembling, impossible to find the screws
serain.loic - Resolved on Release Reply
Seal change completed thank you very much, the collar was difficult to put back but with a little patience and cutting pliers (the cutting ends allowed the folded part of the collar to pass through) it was done.
a.lemire.adrien - Resolved on Release Reply
Good morning,
I think the torque is 1.6. Can anyone confirm? Thanks
Jérôme Leroy - Resolved on Release Reply
Couple 1mkg, the risk is rather to crush the new seal, therefore leaks…
The newer models have 10mm nuts, not 13mm.
Sébastien VENANT - Resolved on Release Reply
