Difficulty
Moderate
Steps
5
Time Required
00:30:00 - 01:00:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Operation carried out on a Twingo 1 phase 2 D4F 1.2I 16V 75hp engine.
Tools
Parts
-
-
-
The order of connection is very important. Mark each cable carefully before disconnecting them.
-
I put on Rislan collars of different colors to make sure I didn't make a mistake.
-
Cable 1 with cylinder #1: no collar.
-
Cylinder #1: flywheel side cylinder.
-
Cable 2 with cylinder no. 2: red collar.
-
Cable 3 with cylinder no. 4: green collar.
-
Cable 4 with cylinder no. 3: yellow collar.
-
Disconnect all câbles candles by pulling on them.
-
-
-
Disconnect the connector by pulling on it.
-
Using a Torx T30 screwdriver, remove the 3 screws and take out the bobine.
-
-
-
Reassembly is carried out in reverse order.
-
Put them back together câbles in the correct order.
-
Cancel: I did not complete this guide.
2 other people completed this guide.
4 Comments
thanks to the author He doesn't think he's a movie star, no spelling or diction mistakes! Plus he's efficient! THANK YOU
michelcuzin - Resolved on Release Reply
A big thank you for this tutorial which saved me from sending my car to the scrapyard!!! following 2 mechanics who did not see that I had reversed the direction of the wires, for them the engine was HS.
steve lacoste - Resolved on Release Reply
Hello
There are only 4 wires. All the same and different lengths! ? In any case, it's good that there are nice people to make tutorials.
Have a nice day and long life to this little Twingo which is, whatever you think, a good little car that is relatively reliable and yet, it came to replace my Safrane Initiale 2.5 5 cylinders, a rolling living room! It was something else of course.?
marc7792 -
