Difficulty
Moderate
Steps
9
Time Required
01:00:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Intervention carried out on a Ford Fiesta 1.3 60hp from 2002
-
-
To remove the ball joint from the spindle you need a 15mm socket and a T50 male torx socket
-
-
-
Using a 15mm socket and an 18mm open-end wrench, remove the bolt.
-
-
-
For the screw you need a 15mm socket.
-
Unfortunately we don't have access to the nut.
-
-
-
Using a Torx T30 screwdriver, remove the 2 screws.
-
Using a Phillips screwdriver, remove the screw.
-
Remove the mudguard.
-
Using the 15mm socket and 18mm open-end wrench, remove the bolt.
-
-
-
To avoid rust, take advantage of the fact that your mudguard is removed to remove as much dirt as possible.
-
-
-
Press the triangle to dislodge the ball joint from the spindle.
-
Then pull the triangle to rotate it.
-
And finally pull on it again to remove it completely.
-
Cancel: I did not complete this guide.
3 other people completed this guide.
