Replacing your license plates

Using a drill or a chisel, remove the 2 rivets that hold the license plate in place.

Clean the surface.

Remove the protective film.

Present your plate and drill it and the bumper.

Personally, I use black rivets so I drill on the dashes. The rivets will not be seen once installed.

Insert your rivet into the plate and the bumper.

I use Ø4x16 rivets.

So I put tip 4 on my rivet gun.

Insert your pliers into the rivet stem and then press the pliers on the head of the rivet so that the plate is also pressed against the bumper.

Pull the trigger once then place the pliers back against the rivet head and repeat until the rod breaks.

Do the same for the 2nd rivet.