Difficulty
Moderate
Steps
8
Time Required
01:00:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Replacing the stabilizer bar bushings on Peugeot 308 from 2007 to 2013. Tutorial also valid for c4, 3008, 307
-
-
Securing the vehicle: removing and refitting the wheel -
Remove the front wheels.
-
-
-
Unscrew the 8 screws with a ratchet and a 10 socket.
-
-
-
Unscrew the lower nut of the stabilizer bar links on both sides of the vehicle.
-
A 16 flat wrench and a T30 torx bit to hold the ball joint during loosening.
-
Lever to disconnect the link from the stabilizer bar.
-
-
-
Unscrew the nut and the bearing screw.
-
The nut using a ratchet and a 21 socket.
-
If the screw head turns, lock it using vise grips.
-
The torx screw using a ratchet and an E16 socket.
-
-
-
Spread the edges of the old pad apart so that it can be removed.
-
Compare the new pad with the old one.
-
Proceed to replace the new pad
-
Align the flats on the bushing with the flats on the stabilizer bar.
-
Make sure the bearing is perfectly positioned when refitting the bearing.
-
-
-
Tighten the nut
-
Tighten to 11 daN.m
-
Tighten the torx screw
-
Tighten to 10 daN.m
-
-
-
Leverage by pressing on the stabilizer bar while leaning on the cradle.
-
Re-couple the tie rod with the stabilizer bar.
-
Tighten the nut.
-
Tighten to 4 daN.m
-
-
-
Replace the plastic cover
-
Tighten the 8 nuts.
-
Tighten the wheel bolts to 10 daN.m
-
Cancel: I did not complete this guide.
4 other people completed this guide.
