Skip to main content

Introduction

We will work with the window open for greater ease.

  1. 
pull the upper part of the cover by hand

then the lower part

then the front
    • pull the upper part of the cover by hand

    • then the lower part

    • then the front

  2. 
move the cover aside but not too much because the speaker jack is still connected

there is no need to disconnect it, just remove the wires from the white grommet by slightly spreading it apart

leave cache pending
    • move the cover aside but not too much because the speaker jack is still connected

    • there is no need to disconnect it, just remove the wires from the white grommet by slightly spreading it apart

    • leave cache pending

  3. 
if your vehicle is equipped with one, remove the plug from its housing by pulling it towards the rear of the vehicle

To unplug the plug, press the tab (circled in yellow)

and shoot
    • if your vehicle is equipped with one, remove the plug from its housing by pulling it towards the rear of the vehicle

    • To unplug the plug, press the tab (circled in yellow)

    • and shoot

  4. 
remove the 3 mirror fixing screws using the T30 torx key

no risk of the mirror falling because the adjustment control holds it

go outside the vehicle and pull the rearview mirror towards you
    • remove the 3 mirror fixing screws using the T30 torx key

    • no risk of the mirror falling because the adjustment control holds it

    • go outside the vehicle and pull the rearview mirror towards you

    • Care must be taken to ensure that the adjustment control and the electrical socket do not become jammed

  5. 
clean the exterior of the door

clean the exterior of the door
    • clean the exterior of the door

  6. 
you will have to insert the rearview mirror lugs into the housings in the bodywork, without forgetting the socket and the rearview mirror control

present the rearview mirror

put it in place
    • you will have to insert the rearview mirror lugs into the housings in the bodywork, without forgetting the socket and the rearview mirror control

    • present the rearview mirror

    • put it in place

  7. 
make sure everything is in place, including the mirror control collar

screw the 3 mirror screws with the T30 torx key

Check that the mirror is working properly before continuing
    • make sure everything is in place, including the mirror control collar

    • screw the 3 mirror screws with the T30 torx key

    • Check that the mirror is working properly before continuing

  8. 
reconnect the plug by pressing it (you should hear a "click")

you will have to position the back of the socket on the slide (circled in yellow)

then slide it towards the front of the vehicle
    • reconnect the plug by pressing it (you should hear a "click")

    • you will have to position the back of the socket on the slide (circled in yellow)

    • then slide it towards the front of the vehicle

  9. 
Pass the speaker wire through the white grommet

and present the cache
    • Pass the speaker wire through the white grommet

    • and present the cache

  10. 
press the top of the cover

then on the bottom

then on the opposite side
    • press the top of the cover

    • then on the bottom

    • then on the opposite side

Finish Line

a_bosc2000

Member since: 11/03/2019

28,441 Reputation

147 Guides authored

One Comment

Well done! Very well explained!

christiancartiaux - Reply

Add Comment

View Statistics:

Past 24 Hours: 6

Past 7 Days: 35

Past 30 Days: 150

All Time: 8,440