Tools
Parts
-
-
The hood is unlocked with the lever located under the handbrake.
-
Under the hood, press the lever so that it can be opened.
-
Secure the opening with the jack on the right
-
-
-
Unscrew the 2 orange Phillips screws in the photo
-
Unscrew the 4 red screws in the photo with a TORX T45 key
-
Remove the plastic protection
-
-
-
Place a piece of cardboard on the windshield so as not to scratch it when the wipers are removed.
-
Lift the wipers. To remove the old wipers there is sometimes a small clip that you have to press, it differs depending on the brand of the wiper. By pressing on this clip pull the wiper in the direction shown by the red arrow in the photo.
-
The wiper is removed, do the same with the second one
-
-
-
Insert l'essuie glace by proceeding in reverse order to its removal. Pressing the clips is not necessary
-
Check that the wiper arm stops properly as shown in the photo opposite.
-
Do the same for the second one.
-
-
-
Remove the cardboard
-
Reattach the two hoses to each wiper.
-
Reinstall the plastic protection plate using the 4 TORX T45 screws and 2 Phillips screws.
-
Close the hood by dropping it about 20 cm so that it locks.
-
The change is a little more delicate than on classic cars because it is necessary to remove a protective cover and the jet hoses. It is nevertheless an easy operation.
The change is a little more delicate than on classic cars because it is necessary to remove a protective cover and the jet hoses. It is nevertheless an easy operation.
Cancel: I did not complete this guide.
One other person completed this guide.
2 Comments
I confirm, there is no point in removing the grille, you just have to activate the windshield wipers and turn off the ignition so that they stay in the high position. It takes 3 minutes to change them
Thuang AH-VANE - Resolved on Release Reply
There is no need to remove the plastic grille. Leave the bonnet closed, switch on the ignition, then switch it off and immediately activate the wiper control. The blades are positioned vertically in the middle of the windscreen. They can then be changed very easily.
pierre bernard - Resolved on Release Reply

