Introduction
It is necessary to be two people to bleed the brake circuit.
-
-
Raise the vehicle and secure it on jack stands
-
Remove the rear wheels
-
Securing the vehicle: removing and refitting the wheel
-
-
-
Unscrew the two 13 screws using la clé plate de 13 et de 15 to hold the lock nut on the slides
-
-
-
Using a flat screwdriver, remove the handbrake cable from its housing.
-
Then pulled it down
-
-
-
Reassemble the brake pipe
-
Reassemble the handbrake cable
-
-
-
For this step it is necessary to be two people
-
Remove the black cover
-
installed the brake fluid recovery tank
-
A person must be in the passenger compartment to pump the brake pedal
-
You have to pump the brake pedal 3 or 4 times then hold it down.
-
While still pressing the pedal, open the bleeder screw using the 10 mm flat wrench until the brake pedal reaches the floor.
-
Repeat this operation until no more air comes out of the bleed screw.
-
Do the same on all four wheels.
-
-
-
Put the wheels back on
-
Place the vehicle on the ground
-
Check the brake fluid level which should be between the minimum and maximum
-
Take advantage of the brake caliper replacement to replace the rear brake discs and pads if necessary
Take advantage of the brake caliper replacement to replace the rear brake discs and pads if necessary
Cancel: I did not complete this guide.
3 other people completed this guide.
3 Comments
Technically very well done, but the conjugation of the verbs of the first group and the past participles should be reviewed....
daniel.pluvinage - Resolved on Release Reply
Hello, I would like to have more details on bleeding the brake fluid. You just have to remove the air from each caliper and top up the level if necessary?
maxime nuzzo - Resolved on Release Reply
Hello dear contributor,
To perform a brake bleed you can go to the following tutorial: Bleeding the brake fluid
We remain at your service,
The Oscaro Team
