Tools
Parts
-
-
Intervention area. There are only 2 screws to remove to access the fog light.
-
It is not necessary to lift the vehicle or remove the wheel. You can do this to have more space because we will intervene on the ground
-
All 1
-
Still 2
-
-
-
When you bend down under the vehicle you will see the bulb cover. Press the tab to release the cover.
-
Once unclipped, remove the cover by pulling towards you then downwards to release the 2 upper notches
-
-
-
Press the retaining spring and shift it to the right to release it from its notch.
-
Then tilt it upwards to release the bulb, taking care to spread the beam
-
-
-
Pull the bulb at the connector to remove it
-
Compare vos ampoules to ensure that they are identical. You can see the lugs that you use to correctly position your bulb
-
Reassembly is carried out in reverse order.
-
When replacing the new bulb, make sure that you are correctly positioned at the lugs and the key (see step 4)
-
Cancel: I did not complete this guide.
One other person completed this guide.
2 Comments
Good morning,
If you have replaced the fuse and it still does not work either at the front or at the rear, it is probably at the level of the control that you have a problem. The other functions of your switch do not have a problem? Turn signal and full beam work correctly? It is possible that it is this switch that is at fault.
Sincerely
Hello, I changed the bulbs in my fog lights and they still don't work. I checked all the fuses and they are good and the light comes on on the dashboard but otherwise the fog lights don't work either at the front or at the back. What could be the fault?
Thank you for your reply. Kind regards.
Elodie
