Replacing the license plate light bulbs.

Kadjar 1.5 DCI from 2019, intense full LED finish.

You have to open the vehicle and open the trunk to see them.

Rear view camera.

Trunk release button.

Position of the license plate lights.

Slot for passing a flat screwdriver to unclip the bulb holder block.

Pass the screwdriver to remove the trunk strip block.

Here the support block is removed from the strip.

We can see the clip holding it in place.

Unclip the power cable connector from this block by pressing the lock.

The transparent cover must be removed to access the bulb.

There is a clip on each side to remove the transparent cover.

Here are the two lugs to be released last when lifting the hood.

The clips are thin and fragile.

Here the cover is removed.

We see the original bulb in place.

Here is the bulb removed from its light block.

Bag of LED modules to replace W5W bulbs.

Here are the two products side by side.

The original W5W bulb.

The LED module.

Be careful of static electricity when opening the LED module bag.

Place the support block before closing the transparent cover.

Power on by turning on the night lights.

We can see the difference in brightness between the two.

Installing the cover and repositioning the lighting unit.

Proceed in the same way for the second lighting block.

Here is the result of this replacement.