Skip to main content
  1. remove the cover under the steering wheel by pulling towards you consult the car's instruction manual and find where the low beam fuse is and disconnect it. In this case it is location F2
    • remove the cover under the steering wheel by pulling towards you

    • consult the car's instruction manual and find where the low beam fuse is and disconnect it.

    • In this case it is location F2

  2. fuse to disconnect
    • fuse to disconnect

  3. locate the cap behind the low beam optics remove the projector cap by pulling the tab Pull the connector to disconnect it
    • locate the cap behind the low beam optics

    • remove the projector cap by pulling the tab

    • Pull the connector to disconnect it

  4. Unclip the bulb retaining clip by pushing and move it to the right to release the bulb retainer. Rotate the clip upwards
    • Unclip the bulb retaining clip by pushing and move it to the right to release the bulb retainer.

    • Rotate the clip upwards

  5. Do not touch the bulb if it has recently been turned on. remove the bulb Compare the new bulb with the used one
    • Do not touch the bulb if it has recently been turned on.

    • remove the bulb

    • Compare the new bulb with the used one

    • bulb position

    • Do not touch the glass of halogen bulbs, this degrades their quality

  6. reposition the bulb in the projector Fold the clip down to secure the bulb reconnect the connector
    • reposition the bulb in the projector

    • Fold the clip down to secure the bulb

    • reconnect the connector

  7. reposition the projector cap reconnect the fuse Replace the plastic cover of the fuse box
    • reposition the projector cap

    • reconnect the fuse

    • Replace the plastic cover of the fuse box

    • Test the operation of your dipped headlights

Finish Line

11 other people completed this guide.

Daniele Brocceri

Member since: 05/18/2017

331 Reputation

1 Guide authored

9 Comments

Merci beaucoup pour ce tuto , par contre faire tres attention a ne pas perdre le clip de maintien de l'ampoule

Dessouhant - Reply

It is impossible to access the bulb without removing the headlight or the fuse box. Well done Peugeot engineers, they have an interest in calling on professionals. For !A !!bulb

jackymigeon - Reply

It is impossible to access Lempoul without removing the headlights, well done Peugeot engineers, it should have been easier to contact a professional and of course an additional cost

jackymigeon - Reply

It's very simple, just take a pair of bent-nose pliers and pull on the connector. No clips, it's the connector that holds the bulb. With the pliers, pull on it because it's stuck. Put the other one in place by looking into the optics and not at the shutter. Put the connector and the cap back on and that's it

bruno jouassin - Reply

On 208 1.4 HDI 2013, there is no longer a retaining spring as in the photo, you pull or push the bulb directly (after disconnecting the connector) that's all, when it works! For my left light, same problem because of the fuse box that gets in the way. In addition, the bulb does not want to be placed in the middle in the axis, the two side springs are not symmetrical, I think I have to change the optics, out of warranty...

Philippe CONCEICAO - Reply

Add Comment

View Statistics:

Past 24 Hours: 32

Past 7 Days: 213

Past 30 Days: 1,098

All Time: 117,963