Difficulty
Easy
Steps
7
Time Required
01:00:00 - 02:00:00
Tutoriel complet
Ce tutoriel contribué par la communauté est complet et prêt pour l'examen de l'équipe Oscaro.
Ce tutoriel a été créé par la communauté
User contributed
Introduction
This tutorial shows you how to replace the catalyst of the 206 1.4 i 75cv.
This operation is not complicated with the right tools.
Before starting and to make the disassembly task easier, spray penetrating oil on the various screws
-
-
Unscrew the lambda probe from the catalyst, either using a 22 mm flat spanner or a socket.1/2 disassembly of lambda probe"
-
-
-
Remove the screws that secure the catalyst to the exhaust pipe
-
-
-
Remove the 4 nuts that hold the catalyst to the manifold. To do this, use a socket wrench with an extension and a 13 mm socket.
-
Remove the screw holding the catalyst to the chassis using a universal joint wrench and a 16 socket.
-
Remove the catalyst
-
Finally remove the metal seal (photo 3)
-
-
-
Comparing the two catalysts
-
Grease the new screws
-
Place the new metal gasket provided on the manifold
-
Position the new catalyst on the manifold, placing a nut to hold it in place as well as the screw holding it to the chassis.
-
Place the other 3 nuts and tighten them all
-
-
-
Place the supplied gasket on the end of the catalyst
-
Connect the catalyst to the exhaust pipe
-
Place the new screws + spring provided and tighten
-
-
-
Finally, replace the lambda probe previously greased with graffiti and screw
-
Cancel: I did not complete this guide.
4 other people completed this guide.
8 Comments
Hello, nice tutorial! Do you have to lower the front bumper? Thanks
Hello. Thank you. No need to lower the bumper.
Hello, I would like to carry out the operation on a 2000 Saxo 1.4 i petrol. Are they the same engines? Thank you.
Sincerely
Fabrice
Good morning,
I put some WD40 on it 24 hours before my surgery. That must have helped because I had no trouble unscrewing it. Plus I was in a pit so no more strength.
Courage
