Installing Roof Bars

Locate the parts of the kit

Locate the parts of the kit

Each skate has a number, they each have a location relative to the roof

4 slots are available for skates

To free up access to these locations, push the hatch down and push it to the side

Repeat the same operation on the 4 locations

Repeat the same operation on the 4 locations

Repeat the same operation on the 4 locations

An arrow indicates the front of the vehicle, place the arrow in the forward direction

Place the skate on the location

Repeat the same operation for the other skates

Split the bars in two

Remove the covers at the end of the bars using an Allen key

Remove the 4 covers

Loosen the 4 supports

Place 2 supports on the first bar then replace the covers removed previously

Place the first bar, the supports on the skates

Insert comment.

Mount the other two brackets on the second bar

Place the second bar, the supports on the skates

Insert comment.

Place two washers per screw, one wavy and one flat

Insert one screw per bracket and tighten it using the Allen key

Insert a screw into the second bracket

Tighten each side of the bar without forcing it too much.

Adjust the length of the bars using the ruler located under the bar

Tighten the screw under the bar to lock it in place

Place the support covers once the screw is tightened

Place the second support cover on the outside

Lock with the key and then retrieve it

Once the 4 keys have been collected

Shake the bars to check that they are properly secured.