Check all levels of your Clio 3

Windshield washer fluid.

Oil filling

Engine oil level indicator.

Brake fluid.

Coolant.

Make your level on a flat ground with a cold engine for perfect precision!''

To open your hood on Clio 3:

After opening the driver's door, bend down to see the lever that you will need to pull towards you.

The hood will therefore be a little open, pass your hand then press the tab on the left side.

To check your oil level, pull the yellow eye upwards.

Wipe with a clean cloth then put it back in the compartment.

You will see that oil has been put back on the tab, you have the maximum as well as the minimum on it.

Do your level on flat ground with a cold engine for perfect accuracy!

Are you low on oil after topping up?

Open your engine oil filler cap , pour your oil delicately with a funnel without filling it, pour on demand then redo your level to adjust each time.

Once the level is done, check that the oil does not exceed the maximum level, otherwise remove it.'' You should always put the level a little above the maximum.

To check your brake fluid you will have to move the plastic container from right to left to see where the fluid is, check carefully not to exceed the maximum level which is displayed on the side of the container.

When filling the coolant, you have a minimum and maximum level to be strictly observed.

Lean over to look behind the container and fill to the maximum level without going over it!

Do your level on flat ground with a cold engine for perfect accuracy!

To fill the windshield washer you will need to remove the cap on top and then fill to the maximum until you see the fluid.