Skip to main content

Introduction

Changing the turbo boost sensor

Parts

  1. 
Open the engine hood using the handle at the pedal level.
    • Open the engine hood using the handle at the pedal level.

  2. 
Lights on due to faulty sensor
    • Lights on due to faulty sensor

  3. 
Locate the sensor location

Locate the sensor location
    • Locate the sensor location

  4. 
To replace it, you have to unclip the connector by leveraging it with a flat screwdriver. Be careful not to break the plastic clips. The plastic can harden and become brittle.
    • To replace it, you have to unclip the connector by leveraging it with a flat screwdriver. Be careful not to break the plastic clips. The plastic can harden and become brittle.

  5. 
unscrew the sensor held in place with 2 size 25 torx screws.
    • unscrew the sensor held in place with 2 size 25 torx screws.

  6. 
To install the new one, you have to do the complete opposite of what you just did.
    • To install the new one, you have to do the complete opposite of what you just did.

Finish Line

One other person completed this guide.

pierre-yves carlier

Member since: 06/09/2020

187 Reputation

3 Guides authored

3 Comments

Hello, for me, loss of power, light that comes on when accelerating, turbo or sensor, thank you

alain.bouvart - Resolved on Release Reply

Hello on a seat ibiza 2011 16 it is in the same place please

cecile.66000 - Resolved on Release Reply

Good morning,

Is this sensor also called "turbo pressure regulator", I need to change the regulator but I don't know what it is or where it is in the engine... thanks in advance!

meyer baptiste 51 - Resolved on Release Reply

Add Comment

View Statistics:

Past 24 Hours: 11

Past 7 Days: 47

Past 30 Days: 170

All Time: 10,071