Skip to main content

Introduction

Vehicle engine 1.4 HDi 70 hp

  1. Perform the removal of the steering ball joint as described in steps 1/2/3 and 4 of the following tutorial
  2. Cut the small clamp tight on the inner steering ball joint axle Cut the large hose clamp that holds the bellows to the rack Cut the large hose clamp that holds the bellows to the rack
    • Cut the small clamp tight on the inner steering ball joint axle

    • Cut the large hose clamp that holds the bellows to the rack

  3. Remove the lock nut from the axial ball joint. Pull the bellows to slide it along the axial ball joint. Pull the bellows to slide it along the axial ball joint.
    • Remove the lock nut from the axial ball joint.

    • Pull the bellows to slide it along the axial ball joint.

  4. Compare Bellows A holed or torn bellows no longer protects the axial ball joint and the rack.
    • Compare Bellows

    • A holed or torn bellows no longer protects the axial ball joint and the rack.

  5. Insert the bellows onto the inner ball joint axle Clean the shoulder on the rack body The outer part of the bellows must coincide with the groove of the axial ball joint.
    • Insert the bellows onto the inner ball joint axle

    • Clean the shoulder on the rack body

    • The outer part of the bellows must coincide with the groove of the axial ball joint.

  6. Place hose clamps on both ends of the bellows. Replace the lock nut
    • Place hose clamps on both ends of the bellows.

    • Replace the lock nut

  7. Reinstall the steering ball joint as described in steps 6/7 and 8 of the following tutorial.
Finish Line

3 other people completed this guide.

hemissi-nizar

Member since: 01/16/2017

21,003 Reputation

88 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 13

All Time: 1,565