Introduction
Vehicle engine 1.4 HDi 70 hp
Parts
-
-
Raise and block the front of the vehicle. Remove the 2 wheels.
-
-
Locate the silent block
-
Remove the stabilizer bar link nut and disconnect it. Use a 16 mm wrench and a bit Torx T40.
-
-
-
Remove the stabilizer bar bearing mounting screw using an 18 mm wrench.
-
The screw can be accessed from the left or right relative to the suspension strut.
-
-
-
Rotate the bearing flange to remove it.
-
Rotate the silentbloc to spread the notch and pull it outwards to remove it.
-
-
-
Compare the dimensions of the silentblocs.
-
Clean the flange and stabilizer bar before installing the new silentbloc.
-
-
-
Grease the silentbloc and the stabilizer bar with silicone grease to prevent squeaking.
-
Fit the silent block onto the bar through the notch. Position it on the flats of the stabilizer bar.
-
Replace the flange and screw.
-
-
-
Tighten the flange screw.
-
Replace the link on the stabilizer bar.
-
Cancel: I did not complete this guide.
7 other people completed this guide.