Introduction
Vehicle engine 1.4 HDi 70 hp
-
-
Raise and block the front of the vehicle. Remove the front wheels to access the stabilizer bar links.
-
-
Before removal, compare the new part.
-
-
-
Using a T30 Torx bit and a 16 wrench, remove the nut from the upper ball joint of the tie rod.
-
Once the nut is removed, do not release the axle from its support.
-
In the same way, remove the nut from the lower ball joint.
-
-
-
Remove the 2 connecting rod pins.
-
Compare the new connecting rod and the old one
-
Clean the supports with a cloth and position the pins of the new connecting rod inside.
-
-
-
Install the new nuts supplied with the new billet.
-
Hold the axle with the torx bit and tighten the nut. On both ball joints.
-
Do the same on the opposite wheel.
-
Reinstall the wheels and check for proper operation.
-
Cancel: I did not complete this guide.
5 other people completed this guide.
