Difficulty
Moderate
Steps
7
Time Required
01:00:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
This tutorial helps you to change the rear shock absorbers on Seat Ibiza IV 1.4 TDi FAP 80 hp
-
-
Choose a flat area and chock the front wheels.
-
Place the box on the candle: Securing the vehicle: removing and refitting the wheel
-
-
-
16 flat key
-
Loosen the bottom screw using a 16 socket.
-
-
-
Shock absorber stop which is fixed to the chassis by 2 screws of 16.
-
Unscrew the 2 16 mm screws
-
-
-
Compare old and new shock absorber
-
Remove shock absorber stop
-
Shock absorber protection
-
Unscrew the nut using the 16 wrench while holding the stud with the adjustable wrench to prevent the shock absorber from turning.
-
-
-
Assemble the bellows and the plastic protection
-
Insert the bellows into the shock absorber stop
-
Insert the stop and the protective bellows into the shock absorber axle
-
-
-
Reposition and screw the shock absorber stop
-
Reposition the lower shock absorber mounting
-
Cancel: I did not complete this guide.
5 other people completed this guide.
3 Comments
This tutorial is great. We'll implement it next week :)
————————-
I would like to add the couples (found on the digital RTA):
Rear shock absorber upper mount:
- 1st pass: 3 daNm
- 2nd pass: 90°
Rear shock absorber lower mounting:
- 1st pass: 4 daNm
- 2nd pass: 90°
Rear shock absorber rod nut: 2 daNm
kilian.russell - Resolved on Release Reply
