In your tutorial, you have to remove the two screws from the rear brake caliper and then use a lever arm to remove the brake pads and then the disc retaining screw. At this stage, it is specified that you remove the used disc. Is this operation possible without removing the caliper support? (We can see that the outer brake pad support hinders the removal of the disc). If this removal is necessary, it is not included in the tutorial.
5 Comments
Good evening,
In your tutorial, you have to remove the two screws from the rear brake caliper and then use a lever arm to remove the brake pads and then the disc retaining screw. At this stage, it is specified that you remove the used disc. Is this operation possible without removing the caliper support? (We can see that the outer brake pad support hinders the removal of the disc). If this removal is necessary, it is not included in the tutorial.
emd01 - Reply
Good morning,
I don't know how it works but the system is normally the same. But I have heard often if the case is needed for the electric handbrakes...
neotix92 - Reply
If we have an electric handbrake. Not automatic. If I release it, do the pistons move back at the same time?
luciani_a - Reply
Good morning,
You have to turn clockwise.
neotix92 - Reply
Good morning,
Which way should we turn to push the piston clockwise or anti-clockwise? Thanks in advance.
sebastien Guerra - Reply