Changing the rear drums and linings on Peugeot 206 hdi

Remove the drum cover

Remove the 32 nut

Remove the drum

Remove the rivet heads by pressing the spring and rotating it

Remove the brake cable by compressing the spring

Unblock the feed pipe with a key of 11

Remove the master cylinder bolt

Disconnect the brake power supply and remove the master cylinder

Use the master cylinder bleeder dust cap to seal the brake fluid inlet.

Clean the flask using brake cleaner

Reposition the master cylinder without forgetting to remove the cap

Screw the brake supply back on

Reattach the master cylinder

Unlock the feed bolt

Check the correspondence between the new fillings and old fittings

Replace the handbrake cable

Reposition the jaws on each side of the master cylinder

Remove the blue protection

Reposition the 2 jaws

Reposition the rivets and springs

Perform a pre-adjustment with the pre-wheel located between the two jaws

Retrieve the ABS ring and replace it on the new drum

Clean the drum using brake cleaner

Replace the clamp clips

Replace the drum and washer and tighten

Reposition the central cover

Bleeding the brakes: Bleeding the brake fluid