Difficulty
Easy
Steps
5
Time Required
00:15:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Here we will see how to change the ODB bulbs when the screen starts to go black.
Tools
Parts
-
-
The middle of the screen is blacked out.
-
Remove the cap by pulling it forward.
-
Put the cap aside.
-
Pay attention to the hazard warning light cables.
-
-
-
Remove the 2 torx screws.
-
Pull the display towards you.
-
Be careful with the ODB cables, don't pull too hard.
-
Remove the display cable from the odb. Press where the red arrow is
-
slide the safety framed in blue.
-
Disconnect the cable completely and then remove the display.
-
-
-
Remove the display.
-
Here are the 3 bulbs to change.
-
Remove the bulb holders using pliers turning a quarter turn.
-
-
-
Here are the 3 bulb holders.
-
Remove the bulb by pulling on it.
-
Check the new bulb (circled in green) against the old one.
-
Insert it into its support by pushing it.
-
-
-
Replace the 3 bulb holders on the display, tightening them a quarter turn.
-
Reconnect the display to the vehicle.
-
Check that everything works before replacing the 2 torx screws.
-
Replace the 2 torx screws and the cap.
-
Cancel: I did not complete this guide.
2 other people completed this guide.
3 Comments
Good morning,
Where is the ODB backlight fuse on 206 HDI 90CV please?
Because I changed the bulbs which were actually blown but it still doesn't work and I don't see anything at the fuse level.
Unless something else is involved.
THANKS
Thank you for this tutorial because I thought since purchasing the vehicle that the problem was electronic and that the only way to solve this problem required a new unit.
Thanks again. My regards!
