Skip to main content

Introduction

Vehicle engine 1.4 HDi 70 hp

  1. 
Disconnect the projector connector by lifting its red locking tab.

Remove the cover located behind the projector.

Remove the cover located behind the projector.
    • Disconnect the projector connector by lifting its red locking tab.

    • Remove the cover located behind the projector.

  2. 
Pinch, push in then spread apart the 2 tabs of the spring.

Then lower the spring.

Do not touch the lamp glass with your fingers.
    • Pinch, push in then spread apart the 2 tabs of the spring.

    • Then lower the spring.

    • Do not touch the lamp glass with your fingers.

    • Replace the lamp, respecting the position of its 3 notches and ensuring that the spring is locked.

    • Check the operation of the fire.

  3. 
Pull the lamp holder backwards.

Replace the lamp
    • Pull the lamp holder backwards.

    • Replace the lamp

    • Check the operation of the fire.

  4. 
The lamp holder is located in the upper part of the projector.

Turn the lamp holder a quarter turn counterclockwise.

Remove the lamp holder and replace the lamp.
    • The lamp holder is located in the upper part of the projector.

    • Turn the lamp holder a quarter turn counterclockwise.

    • Remove the lamp holder and replace the lamp.

    • Check the operation of the fire.

  5. 
The flashing light. Take the old bulb and turn it a quarter turn to release the two small lugs. Replace the new bulb, aligning the same two lugs and lock with a quarter turn. Model PY21W.

The main light. Disconnect the bulb, noting the position of the three tabs. Replace the new bulb, plug in the connector and secure with the two retaining springs. Model H4.

Position light. The bulb holder is not removable. Simply pull on the bulb to disconnect it. To install the new bulb, simply push it into the connector.
    • The flashing light. Take the old bulb and turn it a quarter turn to release the two small lugs. Replace the new bulb, aligning the same two lugs and lock with a quarter turn. Model PY21W.

    • The main light. Disconnect the bulb, noting the position of the three tabs. Replace the new bulb, plug in the connector and secure with the two retaining springs. Model H4.

    • Position light. The bulb holder is not removable. Simply pull on the bulb to disconnect it. To install the new bulb, simply push it into the connector.

Finish Line

6 other people completed this guide.

hemissi-nizar

Member since: 01/16/2017

21,057 Reputation

88 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 15

Past 7 Days: 109

Past 30 Days: 380

All Time: 49,768