Difficulty
Moderate
Steps
6
Time Required
01:00:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Changing the used front brake pads with new brake pads 308 cc 2.0 HDi 16V FAP 140 hp
-
-
after putting the car on a jack stand, remove the wheel, remove the protective rubber to access the two screws that hold the brake caliper (use a screwdriver as in the photo)
-
-
-
Loosen and remove the brake caliper retaining screws using a 7 mm Allen key (turn clockwise to unscrew)
-
-
-
using a screwdriver remove the spring that holds the moving part of the caliper, remove the moving part and place it on top of the disc
-
-
-
Remove the used pads and push the piston back using a piston pusher or a clamp to be able to fit the new pads.
-
-
-
Install the new pads (position the pad with the steel guides in the hollow part of the piston)
-
-
-
Replace the brake caliper on the disc.
-
Proceed with the steps listed above (in reverse order) to ensure proper caliper assembly.
-
Cancel: I did not complete this guide.
2 other people completed this guide.
