Logo l'atelier Oscaro, la mécanique à portée de clic Logo Oscaro

Changing the exhaust gas pressure sensor on Seat Ibiza IV

Written By: pierre-yves carlier (and 2 other contributors)
  • Comments: 5
  • Favorites: 0
  • Completions: 2

Difficulty

Easy

Steps

7

Time Required

00:15:00

Sections

1

Flags

2

Tutoriel complet

Tutoriel complet

Ce tutoriel contribué par la communauté est complet et prêt pour l'examen de l'équipe Oscaro.

Ce tutoriel a été créé par la communauté

Ce tutoriel a été créé par la communauté

User contributed

Introduction

Changing the exhaust gas pressure sensor (FAP)

  1. Open the engine hood using the handle at the pedal level.

    • Open the engine hood using the handle at the pedal level.

    Edit

  2. Lights on due to faulty sensor

    • Lights on due to faulty sensor

    Edit

  3. Locate the sensor location Locate the sensor location Locate the sensor location

    • Locate the sensor location

    Edit

  4. To replace it, you have to unclip the connector by leveraging it with a flat screwdriver. Be careful not to break the plastic clips. The plastic can harden and become brittle.

    • To replace it, you have to unclip the connector by leveraging it with a flat screwdriver. Be careful not to break the plastic clips. The plastic can harden and become brittle.

    Edit

  5. On the 2 hoses, you must loosen the 2 clamps and slide them down to release the hoses. Do not hesitate to use a flat screwdriver to lever the hoses.

    • On the 2 hoses, you must loosen the 2 clamps and slide them down to release the hoses. Do not hesitate to use a flat screwdriver to lever the hoses.

    Edit

  6. Once the 2 hoses and the connectors have been removed, you will need to unscrew the sensor held in place with a size 4 BTR screw. Once the 2 hoses and the connectors have been removed, you will need to unscrew the sensor held in place with a size 4 BTR screw.

    • Once the 2 hoses and the connectors have been removed, you will need to unscrew the sensor held in place with a size 4 BTR screw.

    Edit

  7. To install the new one, you have to do the complete opposite of what you just did.

    • To install the new one, you have to do the complete opposite of what you just did.

    Edit
Finish Line

2 other people completed this guide.

Author

with 2 other contributors

pierre-yves carlier

Member since: 06/09/2020

187 Reputation

3 Guides authored

2 Comments

Hello, on my vehicle I have two hoses, one of them is cut short and is not connected anywhere. Is this normal?

Cordiqlement

Alex85 - Resolved on Release Reply

Hello, is there a recalibration to be done (reprogramming)?

dubosque64 - Resolved on Release Reply

Add Comment



View Statistics:

Past 24 Hours: 7

Past 7 Days: 34

Past 30 Days: 155

All Time: 8,913

Oscaro.com   © 2024 Oscaro.com Tous droits reservés.