Difficulty
Moderate
Steps
8
Time Required
00:30:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
This tutorial helps you perform the oil change on a Peugeot 206 1L9 diesel
-
-
Place a pan under the sump plug
-
Using a 21mm socket wrench, loosen the sump plug, allow the oil to drain into the pan
-
-
-
place the pan under the oil filter
-
With the filter wrench, loosen the filter completely and then remove it from the car.
-
-
-
Put a little oil on the gasket of the new filter and spread it with your finger over the entire gasket
-
put the new oil filter back in place
-
Screw it back in by hand then tighten it slightly with the filter wrench
-
-
-
Place a new gasket on the crankcase plug.
-
Screw the crankcase plug back in by hand then tighten with a 21mm socket wrench.
-
-
-
the oil gauge (green arrow)
-
the cap for oil filling
-
Pour the oil
-
Replace the filler cap and dipstick.
-
Start the engine, let it run for a minute, then turn it off.
-
-
-
Pull the oil dipstick
-
The correct oil level should be just below the maximum, if this is not the case add oil to reach the correct level. (between the 2 arrows)
-
Reposition the oil dipstick
-
Cancel: I did not complete this guide.
One other person completed this guide.
