Difficulty
Easy
Steps
5
Time Required
00:30:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Replacement of the LED indicator of the exterior mirror which also includes a defrosting resistor and the mirror adjustment motor.
Tools
Parts
-
-
Adjust the mirror glass so that you can slide your fingers behind the mirror.
-
Pull it gently
-
Go around to unclip it.
-
-
-
Unscrew the torx screw in the center. Unlike other models of the brand, this is the only screw to remove, the plastic housing the motor is also clipped in 3 places.
-
Remove the painted shell from the mirror by using a flat spatula and sliding it between the indicator and the shell, pushing gently upwards.
-
Unclip the motor.
-
-
-
Remove the torx screw in the photo.
-
Remove the motor connector.
-
Unclip the plastic trim that goes around the rearview mirror.
-
-
-
Remove the 2 torx screws.
-
Remove the torx screw to release the turn signal and remove the turn signal connector.
-
Proceed to reassembly in reverse order. Do not hesitate to observe the rearview mirror from the other side to see the orientation of the visible plastic parts.
-
Cancel: I did not complete this guide.
2 other people completed this guide.
2 Comments
I also succeeded,
I didn't find it that easy,
The indicator repeater is fixed by 2 screws on the black plastic support. The 2nd is not immediately accessible.
I reassembled the new repeater without having dismantled the upper painted shell, I was afraid of breaking it.
Thanks to the author for this tutorial
Great thanks, I did it the first time! Not a mechanic at all!
clareramsbottom - Resolved on Release Reply
