Difficulty
Easy
Steps
4
Time Required
00:15:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
We are going to replace the right folding exterior mirror which no longer responds to the electric control.
Tools
Parts
-
-
Open the driver's door and unclip the interior mirror cover by sliding it upwards.
-
We can see the electric cable of the rearview mirror and the 3 torx screws (T25) fixing it to the bodywork. (red circle)
-
-
-
Photo 1: Unclip the trapezoidal plastic cover using a flat screwdriver.
-
Access is provided to all of the electrical connectors for the mirror control.
-
Photo 2: Follow the path of the cable coming from the mirror to the connector, and carefully disconnect it (yellow arrow).
-
-
-
You can then unscrew the 3 torx screws (red circles) securing the mirror and gently remove it from the outside of the car.
-
Photo 2: We compare the two mirrors, at the bottom the old one and at the top the new one.
-
-
-
Photo 1: Position the rearview mirror using the positioning rod (green arrow). Then tighten the 3 torx screws securing the rearview mirror.
-
Finally, we connect the plug to the board.
-
Photo 2: we clip the plastic covers back on, sliding the largest one from the top down into the white plastic clips (yellow arrows).
-
Cancel: I did not complete this guide.
3 other people completed this guide.
3 Comments
Thanks for this tutorial, it allowed me to change my mirror in 5 minutes, and without breaking everything. Well done again
very good tutorial, clear, simple, effective
WELL DONE and thank you
