Video Overview
-
-
Remove the 3 caps windshield wipers
-
Remove the windshield bay by unscrewing the 3 bolts
-
Remove the seal then extract the windshield bay
-
-
-
Unscrew the 3 windshield wiper bolts using a'a ratchet and a 16 socket
-
Using a white pencil, mark the position of the wiper.
-
Unscrew the bolt, position the arm puller and remove the wiper (repeat this operation for the 3 bolts)
-
-
-
Unscrew the 2 screws from the cover then remove it
-
Unscrew the 2 screws on the hatch then remove it
-
Remove the cover from the battery by unscrewing the 2 screws (using'a key of 10)
-
-
-
Unscrew the 2 screws from the cover containing the air filter
-
Pull the cover out of the air filter up
-
Remove the air filter from the cover
-
-
-
Check the correspondence between the old and new air filter (length, width, etc.)
-
-
-
Place the new air filter in its cover
-
Tighten the 2 air box screws
-
-
-
Tighten the 2 screws on the battery cover
-
Reposition the hatch with the 2 notches then screw the 2 screws back in
-
Replace the windshield bay (clip and screw everything back in)
-
-
-
Screw the passenger side windshield wiper back on, taking into account the markings
-
Screw the driver's side windshield wiper back on, taking into account the markings
-
Check that the windshield wipers are working properly
-
Reposition the bay cover by tightening the 3 bolts
-
-
-
Reposition the 3 covers and the windshield wiper nuts
-
Replace the seal
-
Replace the engine cover
Good evening
Thank you for this very detailed tutorial. If I may, it is not necessary to disassemble the wiper arms, just remove the small plastic cover on the driver's side. When reassembling, it is quite easy to put the seal back in place under the plastic covers. This allowed me to save a few minutes.
Jean Michel
-
Cancel: I did not complete this guide.
3 other people completed this guide.
Team
5 Comments
Yes, that's why I saw a lot of badly placed air filters!!!
Good morning,
As "Laurent Guibourdenche" said about the good screwdriver, use a screwdriver like the one found in socket boxes.
Fit a small universal joint onto the screwdriver and you're done.
For the windshield wipers I agree with the other three comments.
I confirm, no need to disassemble the wipers. The most complicated thing is to have the right screwdriver to unscrew the air box.
