Skip to main content
  1. 
Locate the throttle cable.

Locate the throttle cable.

Locate the throttle cable.
    • Locate the throttle cable.

  2. 
Unclip the cable on the pedal side

Remove the cable at the engine compartment and then remove the sealing rubber.

Remove the cable at the engine compartment and then remove the sealing rubber.
    • Unclip the cable on the pedal side

    • Remove the cable at the engine compartment and then remove the sealing rubber.

  3. 
Loosen the circlips then remove the conduit to access the cable

Loosen the circlips then remove the conduit to access the cable

Loosen the circlips then remove the conduit to access the cable
    • Loosen the circlips then remove the conduit to access the cable

  4. 
Remove the adjuster pin (white)

Dislodge the end of the cable from its housing

You can now completely remove the throttle cable
    • Remove the adjuster pin (white)

    • Dislodge the end of the cable from its housing

    • You can now completely remove the throttle cable

  5. 
Check the dimensions and components of the Kit. It is sometimes necessary to cut the new cable depending on your vehicle
    • Check the dimensions and components of the Kit. It is sometimes necessary to cut the new cable depending on your vehicle

  6. 
Position the rubber (wall pass)

Start running the new cable into the passenger compartment through the bulkhead gland

Position the second piece once the sheath has passed through then push it into the rubber part previously laid.
    • Position the rubber (wall pass)

    • Start running the new cable into the passenger compartment through the bulkhead gland

    • Position the second piece once the sheath has passed through then push it into the rubber part previously laid.

  7. 
Run the new cable under the cast iron manifold

Pass the sheath through the adjuster (Black and grooved)

Position and tighten the cable end lug
    • Run the new cable under the cast iron manifold

    • Pass the sheath through the adjuster (Black and grooved)

    • Position and tighten the cable end lug

  8. 
Clip the cable to be retrieved from the passenger compartment and secure it to the end of the pedal
    • Clip the cable to be retrieved from the passenger compartment and secure it to the end of the pedal

  9. 
Once the cable is positioned, install the pin on the adjuster (black) in order to adjust the play (idle) of the accelerator.

Reposition the previously dismantled parts. If the adjustment still does not match, do not hesitate to shorten the cable.

Reposition the previously dismantled parts. If the adjustment still does not match, do not hesitate to shorten the cable.
    • Once the cable is positioned, install the pin on the adjuster (black) in order to adjust the play (idle) of the accelerator.

    • Reposition the previously dismantled parts. If the adjustment still does not match, do not hesitate to shorten the cable.

Finish Line

One other person completed this guide.

mvernierk

Member since: 11/13/2016

1,904 Reputation

3 Guides authored

One Comment

Good job thanks man

mvernierk - Reply

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 10

Past 30 Days: 64

All Time: 1,946