Difficulty
Easy
Steps
4
Time Required
En cours
Ce tutoriel est en cours de création. Revenez de temps en temps pour voir les modifications.
Introduction
This tutorial explains the steps to change the stabilizer bar links on the rear axle. The model used is an e91 330d phase 1.
Parts
-
-
The top screw is held by a 16 nut.
-
On original BMW connecting rods, you have to hold the 16 mm lock nut while you unscrew the 16 mm nut. For the lock nut, you will need a very thin flat wrench.
-
On the new TRW JTS510 connecting rods that I installed, you have to hold the threaded rod with a 5mm Allen key while you screw in the 16 nut.
-
Once the nut is removed, uncouple the tie rod from the stabilizer bar.
-
Unscrew the lower bolt with a 13 wrench.
-
Cancel: I did not complete this guide.
One other person completed this guide.
