Replacement on Citroën C5 II 2.0HDi

Put the vehicle in high position

turn off the engine

Raise the vehicle using the jack and secure it on stands

Open the hood

Remove the engine cover by pulling it upwards

The oil filter is located here

Loosen the oil filter using the strap wrench

Unscrew the screws

Remove the under-engine plate

Place a tray under the vehicle

Using the 21 mm flat wrench, unscrew the drain plug.

Let the oil flow until it drips.

Replace the drain plug gasket

Replace the drain plug with the new copper gasket.

Tighten it using the 21 flat wrench

Reassemble the plate under the engine

Tighten the plate screws

Remove the oil filter cartridge by pulling it outwards

Compare the two oil filter cartridges

Replace the oil filter gasket

Fit the new filter cartridge by clipping it in place

Reassemble the oil filter, starting by tightening it by hand and finishing using the strap wrench.

Pour the oil recommended by the manufacturer into the engine through the filler hole then replace the cap.

Check the oil level with the dipstick

Replace the dipstick and start the engine to fill the oil filter

BE CAREFUL NOT TO EXCEED THE MAXIMUM LEVEL

Check the oil level again with the dipstick

Replace the engine cover

Lower the vehicle back to its initial position

To reset the maintenance indicator on the dashboard, press the "000" button and turn on the ignition.

Hold until the countdown is complete

Here is the reset video