Renault Captur oil change and oil filter

Raise the vehicle using the jack and secure it on stands: Securing the vehicle: removing and refitting the wheel

Open the hood

Remove the oil dipstick

Remove the air inlet hose

The oil filter is located here

Loosen the oil filter slightly using the ratchet and the oil filter bell.

Unscrew the 5 screws of 10 and the 2 of Torx T30

Remove the under-engine plate

Place a drain pan under the vehicle

Using the drain square, unscrew the drain plug

Let the oil flow until it drips.

Replace the drain plug gasket

Replace the drain plug with the new copper gasket.

Tighten it using the drain square

Place the drain pan under the vehicle and remove the old oil filter

Check the correspondence between the old and new oil filters

Fit the new oil filter, taking care to lubricate the seal with used oil before fitting.

Install the new filter

Finish tightening lightly using the ratchet

Reassemble the plate under the engine

Screw in the 5 x 10 screws and the 2 Torx T30 screws

Replace the air hose

Put the vehicle back on the ground

Pour the oil recommended by the manufacturer into the engine through the filler hole.

Pour the oil slowly because the filling hole is very narrow.

Check the oil level with the dipstick

BE CAREFUL NOT TO EXCEED THE MAXIMUM LEVEL

Replace the dipstick and start the engine to fill the oil filter

Check the oil level again with the dipstick