Skip to main content

Introduction

The model presented is a 330d E91 phase 1

  1. 
It connects the rocket to the chassis.

On the chassis side it is fixed by a bolt and a nut.

On the rocket side it is fixed by a bolt.
    • It connects the rocket to the chassis.

    • On the chassis side it is fixed by a bolt and a nut.

    • On the rocket side it is fixed by a bolt.

  2. 
Unscrew the bolts using an 18mm wrench.

On the chassis side you will need an 18mm wrench to unscrew the bolt and another 18mm wrench to lock the nut.
    • Unscrew the bolts using an 18mm wrench.

    • On the chassis side you will need an 18mm wrench to unscrew the bolt and another 18mm wrench to lock the nut.

    • Remove the arm.

  3. 
Reassembly is carried out in the reverse order.

It is very important that the replacement part has the exact center distance length of the original part.

To check that the new part has the same center distance length as the original, simply place the 2 parts on top of each other and insert a screw into each center distance. If the screws go in, then the new part has the correct dimensions.
    • Reassembly is carried out in the reverse order.

    • It is very important that the replacement part has the exact center distance length of the original part.

    • To check that the new part has the same center distance length as the original, simply place the 2 parts on top of each other and insert a screw into each center distance. If the screws go in, then the new part has the correct dimensions.

    • The thread used for the nut, the spindle and the bolts is not standardized, it is an M12 with a pitch of 1.5. 2 precautions are therefore necessary: lubricate abundantly and make sure when you screw that you are well in the axis.

Finish Line

One other person completed this guide.

laurent.immo13003

Member since: 03/03/2016

12,942 Reputation

155 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 6

Past 30 Days: 32

All Time: 1,765