Difficulty
Moderate
Steps
8
Time Required
00:35:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Warm up the vehicle before starting the oil change so that the oil is more fluid
-
-
Raise the car using a jack and use axle stands to ensure your safety.
-
Open the engine hood
-
Remove the oil dipstick and filler cap
-
-
-
Place the drain pan under the vehicle
-
Using the drain wrench, unscrew the drain plug.
-
-
-
Once the oil has drained, replace the cap and tighten it using the drain wrench.
-
-
-
Using the filter wrench, unscrew the old oil filter and place the drain pan underneath to collect the used oil.
-
Compare the two oil filters
-
Oil the gasket of the new oil filter before installation
-
Install the new oil filter, starting by hand tightening and finishing lightly with the filter wrench.
-
Put the vehicle back on the ground
-
-
-
Pour engine oil into the filler hole
-
Check the level
-
Be careful not to exceed the maximum level
-
Replace the oil dipstick and filler cap
-
Start the engine for a few seconds so that the new oil filter can fill.
-
Recheck the oil level
-
-
-
To perform the reset use the button at the bottom right of the dashboard
-
Press it and while holding it down, turn on the ignition.
-
Wait for the countdown to end
-
Turn off the ignition
-
Cancel: I did not complete this guide.
5 other people completed this guide.
