Oil change and oil filter replacement on Touran III 1.6 tdi

Raise the vehicle and secure it on jack stands

Open the hood

Remove the engine cover by pulling it upwards

Le filtre à huile is located here

Remove the T30 screw

Move the metal tab to the side to access the oil filter

Using the ratchet with the extension and the 32 socket, unscrew the oil filters.

Remove the old oil filter

Replace the three seals

Check that le nouveau filtre à huile corresponds to the old one

Clip the new oil filter in

Remove the under-engine plate by unscrewing the T25 and T30 screws.

Place a bin under the vehicle

Unscrew the oil pan plug using a 19 mm wrench.

Once the oil has stopped flowing, replace the cap and tighten it using the 19 wrench.

The cap seal cannot be replaced.

Reassemble the plate under the engine and screw in the T25 and T30 screws.

Reinstall the new oil filter onto the engine, starting by tightening it by hand.

Finish tightening using the ratchet

Pour l'huile recommended by the manufacturer

Check the level

Be careful not to exceed the maximum level

Once the oil has been poured into the engine, screw the filler cap back on and start the engine for a few seconds to fill the oil filter.

Recheck the oil level

To reset, use the buttons on the right of the steering wheel.

Go to settings

Then Service

Then Reset

Click OK

The service has been reset