Video Overview
-
-
Securing the vehicle: removing and refitting the wheel -
Place a drain pan under the crankcase
-
Desserts le bouchon du carter with the drain square
-
Unscrew the drain plug by hand and let the oil flow into the pan.
-
-
-
View the location of the oil filter in the engine
-
Using the cloche à filtre or oil filter wrench loosen the filter then remove the
-
-
-
Compare the old and the new nouveau filtre à huile (height, width, diameter)
-
Lubricate with a little oil around the oil filter gasket
-
Reposition the new gasket on the crankcase plug
-
-
-
Replace the new oil filter in its location then screw the filter back on firmly by hand.
-
You can tighten the filter with the bell but do not tighten too much
-
-
-
Clean the crankcase with a cloth
-
Replace and then screw the crankcase plug back in by hand.
-
Tighten with le carré de vidange the crankcase plug
-
-
-
Start the engine, let it run for a minute, then turn it off.
-
After stopping the engine, pull out the oil dipstick
-
The right level ofhuile should be just below the maximum, if this is not the case add oil to reach the correct level
-
Re-immerse the dipstick and screw the filler cap back on.
-
Cancel: I did not complete this guide.
4 other people completed this guide.
Team
One Comment
Changing the oil in a 2018 Sandero SCE Apply the parking brake.
Raise the car on one side, place a jack stand.
Remove the 8 screws that hold the protection under the drain plug
Remove this protection. Unscrew the drain plug: 8 mm square
Remove the oil filter, obviously having placed a container to collect the oil.
Lower the car to collect the oil completely.
Place the car on a jack stand.
Reassemble the filter, oiling its seal. Tighten very moderately. Some recommend tightening it only by hand.
Replace the cap with a new gasket.
Add 2l 10/40 oil.
Check for leaks, there is no reason to have any.
Reassemble the protection. Remove the jack (rolling is better)
Take the car back down. Put a label in the engine compartment with the km and date.
Please note that it is necessary on this model to remove the plate under the engine.??
I am posting this comment because no one has given me the explanation and no RTA for this model.
