Skip to main content

Introduction

Draining and replacing the oil filter on a T5 multivan 2.5l TDI 130hp from 2007 (BNZ).

  1. 
Warm up the engine for a few minutes

Place the vehicle on a flat area and open the hood
    • Warm up the engine for a few minutes

    • Place the vehicle on a flat area and open the hood

    • Raise the oil pull 5-10 cm to let the air pass through

    • Remove the engine cover by unscrewing the 6 screws with a 13 socket (the bottom of the photo is the bumper side)

    • Pinch the clip to remove the engine cover

  2. 
Place the oil collection pan under the engine crankcase

Unscrew the drain plug with a 19 socket.
    • Place the oil collection pan under the engine crankcase

    • Unscrew the drain plug with a 19 socket.

    • Let the oil flow into the pan

    • Provide a minimum 8L container

  3. 
Locate the oil filter cap (facing the vehicle, on the left, below the power steering fluid reservoir)

Unscrew the power steering reservoir with a 10 socket to make room. Shift it slightly

Unscrew the oil filter cap with a 32 socket and ratchet.
    • Locate the oil filter cap (facing the vehicle, on the left, below the power steering fluid reservoir)

    • Unscrew the power steering reservoir with a 10 socket to make room. Shift it slightly

    • Unscrew the oil filter cap with a 32 socket and ratchet.

    • Replace the oil filter (part number 070115562). Pull to unclip it.

    • Replace the O-ring on the oil filter cap

    • Screw the oil filter cap back on

    • Screw the power steering reservoir back on

  4. 
Once the oil stops flowing, clean the port on the engine crankcase

Replace the drain plug (part number N90813202) with a new one

Screw the drain plug back onto the engine crankcase (lock without overtightening)
    • Once the oil stops flowing, clean the port on the engine crankcase

    • Replace the drain plug (part number N90813202) with a new one

    • Screw the drain plug back onto the engine crankcase (lock without overtightening)

    • Unscrew the oil filler cap

    • Fill the tank with 5W30 LongLife (LL) oil, VW 504 00 / VW 507 00 standard (capacity 7.4L) - Reference: G052195M

    • Screw the filler cap back on.

    • Wait 5-10 minutes for the oil to drain back into the crankcase and check the oil level.

    • VAGCOM is required to reset the maintenance reminder

Conclusion

The steps are simple to do but you have to take your time.

Access to the oil filter is restricted, with a little patience, you can get there.

Good draining!

One other person completed this guide.

alanboucher.info

Member since: 08/20/2017

576 Reputation

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 29

Past 30 Days: 145

All Time: 14,915