Difficulty
Easy
Steps
8
Time Required
01:00:00
Ce tutoriel a été créé par la communauté
User contributed
-
-
Place a tray under the drain plug and unscrew it with a 21 socket.
-
Let the oil drain until it drips.
-
If the vehicle was hot when draining, allow 1 hour to elapse.
-
-
-
Disconnect the hose between the turbo and the air box by first unscrewing the two clamps using a flat screwdriver.
-
Move the hose to the side
-
Do not disconnect this side of the hose
-
Access the oil filter bell and unscrew it using a 27 socket. You may be able to use a universal joint to access it.
-
-
-
Remove the bell equipped with its oil filter
-
Pull firmly on the oil filter to release it from the bell.
-
Fit the new filter onto the bell until you hear a click.
-
Replace the seal around the bell with the new one supplied with the oil filter
-
Be careful that the seal is properly seated in the bell groove and is not twisted.
-
-
-
Replace the bell equipped with its new filter on the engine.
-
Tighten with a 27 socket until a hard point is reached. Do not force more, the bell is made of plastic.
-
Replace the hose between the turbo and the air box and tighten the clamps with a flat screwdriver.
-
-
-
Replace the copper gasket on the drain plug with a new one.
-
Tighten the drain plug with a 21 socket.
-
-
-
Fill the engine with 5W30 oil suitable for the engine and meeting Volvo/PSA standards.
-
Start by adding 3.25L of oil.
-
Check the level with the engine oil dipstick and top up if necessary.
-
Close the filler cap
-
Be careful not to exceed the maximum level of the gauge
-
-
-
Put the key in position 0
-
Press and hold the T1/T2 push button on the dashboard
-
Turn the key to position II
-
Wait about 10s while holding down T1/T2
-
When the service indicator light flashes, release T1/T2. A beep and the maintenance indicator light going out indicate that the maintenance counter has been reset to 0.
-
Cancel: I did not complete this guide.
3 other people completed this guide.
2 Comments
A tip, to have easier access to the filter bell, you can disassemble the air filter unit quite easily (by disconnecting the sensor and pulling upwards after removing the elastic band holding it).
It will be much easier to loosen, remove and replace the bell, especially if you don't have a universal joint.
Otherwise, very practical tutorial ;)
jojolaflem - Resolved on Release Reply
