Oil change - Clio 3

Raise the vehicle and secure it on jack stands

Open the hood

Remove the engine cover by pulling upwards

Remove the cap and dipstick

The oil filter is located here

Remove the air hose to access the filter

Loosen the oil filter slightly using the filter bell

Place the oil collection pan under the vehicle

Loosen the drain plug using the 8 mm drain square.

Wait until the oil has finished flowing

Replace the drain gasket, checking that the new gasket matches the old one

Revise the cork using the drain square

Disassemble the oil filter

Check that the new oil filter corresponds to the old one

Apply oil to the gasket of the new oil filter before reinstalling it.

Place a pan under the vehicle, as oil may leak when removing the old oil filter.

Screw on the oil filter by hand

Finish tightening the filter lightly using the oil filter bell

Replace the air hose

Put the vehicle back on the ground

Pour the recommended oil into the filler hole

Check the level

Be careful not to exceed the maximum level

Replace the oil dipstick and filler cap

Start the engine for a few seconds to allow the new oil filter to fill.

Recheck the oil level

Do not exceed the max level

Clip the engine cover

To reset the maintenance indicator, use the "down arrow" button on the right-hand switch, go to the oil change menu and hold until the dial displays 20,000 km