Introduction
Doing an oil change on your Saxo 1.6l 8s 100hp Also valid for 1.4l phase 3 (those with the vertical catalyst)
-
-
Start by lifting the car on the driver's side with the jack then secure it by placing a jack stand.Securing the vehicle: removing and refitting the wheel
-
This operation must be carried out on flat ground (to adjust the level when filling) and especially not when hot, so as not to burn yourself with the oil!
-
Open the filler cap (black cap with an oil can drawn in yellow)
-
-
-
-
Withdraw the oil filter (located between the alternator and exhaust), while the oil flows into the pan. With a filter wrench oil loosen the filter and finish by hand
-
-
-
Check compatibility of old and new oil filter
-
Put a little oil on the gasket, tighten the new oil filter by screwing it in by hand
-
-
-
Replace the new gasket on the cap and tighten
-
Fill the oil through the filler cap (3l oil). Check the level by pulling the gauge of oil then run the engine for 5 minutes to see if there are any leaks
-
Cancel: I did not complete this guide.
13 other people completed this guide.
3 Comments
A well done tutorial. It would be necessary to add the case of the paper oil filter in the plastic bell and especially how to remove the filter from the bell.
As for me, the part that holds the filter in the bell broke... a bell to change...
Thanks for the info
To reset the oil change interval, position yourself at the driver's seat and hold down the (000) button on the display using your left hand.
Turn on the ignition and wait for the countdown to end 10 9 8 7 6 5 4 3 2 1 = 0 while maintaining the pressure, turn off the ignition then turn it back on, your display will indicate your next service in 20,000 km.
