Difficulty
Moderate
Steps
10
Time Required
00:45:00
Ce tutoriel a été créé par la communauté
User contributed
Introduction
This tutorial is made on Fiat Doblo 1.3 Multijet
Warm up the engine before changing the oil so that the oil is more fluid.
-
-
Raise the car using a jack and use axle stands to ensure your safety.
-
Open the hood
-
Remove the oil dipstick and filler cap
-
-
-
Place the drain pan under the vehicle
-
Using the ratchet of the T45 bit, unscrew the drain plug.
-
-
-
Once the oil has drained, replace the cap and tighten it using the ratchet.
-
-
-
Using the extension ratchet and the 32 socket, loosen the oil filter bell by placing the drain pan under the vehicle.
-
-
-
Install the new oil filter, starting by hand tightening and finishing with the ratchet.
-
Put the vehicle back on the ground
-
-
-
Pour engine oil into the filler hole
-
Check the level
-
Be careful not to exceed the maximum level
-
Replace the oil dipstick and filler cap
-
Start the engine for a few seconds so that the new oil filter can fill.
-
Recheck the oil level
-
Close the hood
-
Cancel: I did not complete this guide.
5 other people completed this guide.
