Draining and changing the oil filter on Twingo 2 1.5 Dci

Raise the vehicle and secure it on candles.

Open the hood.

Loosen the oil filter slightly using the filter bell.

Place the oil collection pan under the vehicle.

Loosen the drain plug using the drain plug wrench.

Wait until the oil has finished flowing, raise the vehicle again, remove the jack stands, so that the car is completely flat.

Replace the drain gasket, checking that the new gasket matches the old one, put the vehicle back on 'candles'.'

Screw the plug back on using the drain square.

Remove the oil filter.

Check that le nouveau filtre à huile corresponds to the old one..

Apply oil to the gasket of the new oil filter before reinstalling it.

Place a pan under the vehicle, as oil may leak when removing the old oil filter.

Screw the oil filter in by hand.

Tighten the filter 3/4 turn using the oil filter bell.

Pour l'huile recommended in the filling hole.

Be careful to pour the oil slowly because the filling hole is small, so the oil flows very slowly.

Check the level.

Be careful not to exceed the maximum level.

Replace the oil dipstick.

Start the engine for a few seconds to allow the new oil filter to fill.

Recheck the oil level.

Do not exceed the max level.

Reset the maintenance indicator on the dashboard using the button at the end of the right-hand switch.

Go to the drain display, and keep the button pressed until the complete reset.

Take old oil and FH to the recycling center

Here is the video of the reset