Draining and changing the oil filter on Renault Twingo 1 phase 2

Unscrew all the screws holding the cover under the engine

Once all the screws are removed, remove the cover under the engine

Place a pan under the crankcase so that the oil can drain.

Using a drain square, loosen the sump plug.

Unscrew le bouchon from crankcase to hand

Remove the cap and leave l'huile flow into the tray

Visualize the oil filter placed under the vehicle

Using a filter wrench or d'une cloche loosen the oil filter

Unscrew the oil filter by hand and remove the

Compare the old and le nouveau filtre à huile (gasket diameter)

Place some oil on your finger and lubricate all around the oil filter gasket

Replace the new oil filter in its location

Tighten the oil filter firmly by hand.

Insert the drain gasket onto the sump plug

Screw the crankcase cap back on.

Tighten the sump plug using a drain square

Reposition the cover under the engine

Replace all screws and tighten them.

Remove the oil cap

Place a funnel

Pour about 3 liters of oil

Replace and screw the oil cap back on.

Start the engine and let it run for a few minutes.

Stop the engine, after 30 seconds pull the gauge

The correct level on the gauge should be just below the maximum, add oil until the level is reached

Replacer la jauge