Video Overview
-
-
Once all the screws are removed, remove the cover under the engine
-
Place a pan under the crankcase so that the oil can drain.
-
-
-
-
Visualize the oil filter placed under the vehicle
-
Using a filter wrench or of a bell loosen the oil filter
-
-
-
Compare the old and the new oil filter (gasket diameter)
-
Place some oil on your finger and lubricate all around the oil filter gasket
-
-
-
Replace the new oil filter in its location
-
Tighten the oil filter firmly by hand.
-
-
-
Screw the crankcase cap back on.
-
Tighten the sump plug using a drain square
-
-
-
Reposition the cover under the engine
-
Replace all screws and tighten them.
-
-
-
Replace and screw the oil cap back on.
-
Start the engine and let it run for a few minutes.
-
-
-
Stop the engine, after 30 seconds pull the gauge
-
The correct level on the gauge should be just below the maximum, add oil until the level is reached
-
Replacer the gauge
-
Cancel: I did not complete this guide.
14 other people completed this guide.
8 Comments
nikel merci beaucoup
Good morning,
What is the engine please?
Well done, but why bother removing the panel under the engine? ...
’
’
Hello, I asked myself the question too, I think it is to access the oil filter.
very good thank you