Draining and changing the oil filter on Peugeot 5008

Unscrew the 7 screws (size 10) securing the plate

Remove the 4 size 10 nuts

Remove the plate

Loosen the drain plug size 21

Recover the plug and the old gasket and let the oil drain into a container.

Locate the oil filter . It is located under the air hoses

Remove the air hose to access the filter

Shift the hose to the left

The bell is visible

Unscrew the bell with a socket and a 27 ratchet.

Compare the old and new filter (especially the tip)

Remove the filter from the bell

Insert the new filter

Pay attention to the lug located at the bottom of the filter which fits into the groove provided for this purpose.

Change the seal on the bell

Screw the filter bell back into place

Replace the drain gasket on the oil pan plug

If the old gasket is not present on the cap, it is probably still stuck to the oil pan , it must be removed and cleaned first.

Screw the cap back onto the crankcase

Open the filler cap

Fill the engine with the oil and the quantity recommended by the manufacturer

Check the level with the dipstick

Mini and vert level

Max level in blue

Adjust the level by adding oil if necessary

Start the vehicle, check the level and adjust if necessary.

Reassemble the engine plate

Reset the maintenance indicator:

Press the odometer reset button

Turn on the ignition

Wait until the 10s countdown ends before releasing the button and then switching off the ignition.