Difficulty
Easy
Steps
14
Time Required
01:00:00
Ce tutoriel a été créé par la communauté
User contributed
-
-
Climb up and place two jack stands on the front of the car
-
-
-
Remove the casing located under the engine with the 10 socket wrench (7 screws to remove).
-
-
-
We can see the oil filter (red circle) and the drain plug (green circle).
-
Install the drain pan under the drain plug
-
-
-
Use the drain wrench to remove the plug
-
let the oil drain + remove the jack stands and lower the car back down
-
Wait until the engine is empty and there is no more dripping.
-
Do not start the engine
-
Reassemble the car and reinstall the 2 jack stands
-
-
-
Use a flat screwdriver to remove the old gasket that is probably still stuck to the engine.
-
-
-
Place the new gasket on the cap
-
Replace the cap + tighten it
-
-
-
Place the drain pan full of oil under the oil filter
-
Use the ratchet + the 27 socket to loosen the filter
-
The filter is full of oil
-
-
-
Remove the 3 oil filter support gaskets and replace them
-
-
-
Place the new filter in the holder
-
Put it back under the engine + tighten
-
-
-
open the oil tank cap.
-
Pour 4 liters + check the gauge, readjust if necessary to have the level between the two lines
-
-
-
Start the engine and let it run for 5 minutes.
-
Stop the engine and recheck the level with the dipstick, if necessary readjust by adding oil
-
I usually put the 5 liters
-
Cancel: I did not complete this guide.
6 other people completed this guide.
9 Comments
Attention for owners of the 1.2 tce (130 hp for me) on the photos of the tutorial we are fooled on the drain plug. If we follow without checking too much we empty the gearbox oil. On the 1.2 the drain plug is on a different metal protection than the one in the tutorial.
factyswear - Resolved on Release Reply
This appears to be a 1.3 TCE engine, it would be good to specify this in the title.
jean-marc.couriera - Resolved on Release Reply
