Drain and change all filters on Nissan X-trail

Open the hood

Raise the vehicle using the jack and secure it on stands

Remove the oil dipstick and filler cap

Remove the 11 clips and the 4 screws of 10 which hold the plate under the engine

Place a tray under the vehicle

Using the drain square, unscrew the drain plug

Let the oil flow until it drips.

Replace the drain plug gasket

Replace the drain plug

Tighten it using the drain square

Loosen the oil filter using the ratchet and the 27 socket.

Remove the oil filter

Remove the oil filter cartridge by pulling it downwards

Check the correspondence between the old and new oil filters

Replace the oil filter gasket

Fit the new filter cartridge by clipping it in place

Reinstall the oil filter using the ratchet and the 27 socket.

Reassemble the plate under the engine

Replace the 11 clips and 4 screws of 10

Put the vehicle back on the ground

Pour the oil recommended by the manufacturer into the engine through the filler hole.

Check the oil level with the dipstick

Replace the dipstick and cap then start the engine to fill the oil filter

BE CAREFUL NOT TO EXCEED THE MAXIMUM LEVEL

Check the oil level again with the dipstick

Locate the air filter

Unclip the staples

Remove the air hose

Open the air box

Remove the air filter

Clean the air box

Check the dimensions between the old and new air filter (length, width, shape)

Install the new filter

Close the air box

Put the hose back on

Put the clips back

The filter is located here

Unscrew the two 13 mm screws

Remove the protective cover

Unscrew the 10 screw holding the filter

Disconnect the hoses

Disconnect the sensor

Plug the filter holes to prevent diesel from leaking out.

Remove filter

Check the correspondence between the old and new fuel filter

Install the new filter

Reconnect the hoses

Reconnect the sensor

Replace screw 10

Replace the cover

Tighten the two 13 screws