Difficulty
Very easy
Steps
2
Time Required
00:55:00
Tutoriel complet
Ce tutoriel contribué par la communauté est complet et prêt pour l'examen de l'équipe Oscaro.
Ce tutoriel a été créé par la communauté
User contributed
Introduction
Fuel filter change on Audi A3 II, year 2005. 2.0 TDi 140hp
-
-
Unscrew the cover screws using the torx key
-
Once unscrewed with a small screwdriver gently lever to remove the cover and the seals
-
then pull the diesel filter upwards from its housing from time to time it tends to resist but insist harder or leverage with a flat screwdriver then you can put the new one back
-
-
-
Place the small gasket in the center in the correct position
-
Then put the second O-ring on the cover as in the photo, add a little diesel to make it easier for the seal to slide in just in case.
-
for tightening proceed in a cross pattern to facilitate the O-ring to be joined everywhere then tighten everything without forcing too much
-
to re-prime the filter, turn the key three or four times without start of course let the pump fill the filter and empty the air
-
Here, start your vehicle and check that everything is fine, there are no leaks.
-
New line.
-
Cancel: I did not complete this guide.
One other person completed this guide.
