Almost done!
Finish Line
Cancel: I did not complete this guide.
11 other people completed this guide.
Cancel: I did not complete this guide.
11 other people completed this guide.
Past 24 Hours: 1
Past 7 Days: 4
Past 30 Days: 12
All Time: 32,627
19 Comments
Good evening,
Thanks for the tutorial that helped me a lot, I just wanted to know because when I disassembled it I saw that the ball joints were filled with grease and I didn't put any on the new ball joints, do I have to disassemble it again to put some? Thanks for the answer.
Virtues.
Didier MOUREN - Reply
Hello Didier, thank you for this comment. For my part, the address is not necessary because the ball joints are of interest to the manufacturer before installation.
sebastienherbomel -
Is your Tulip extractor a 35/45? I have a Scénic 2 1.5 dCI 106CV 2007 166000km, following my MOT, I have the same thing to do as you.
THANKS.
gerard.tacaille - Reply
Yes, that's it, in the third photo of the step we can see the diameters written on the tools.
sebastienherbomel -
Hello
What diameter do I need to loosen the axial ball joint?
I have a Rover 216 GTI on the RTA it is not indicated thank you
Christophe Combredet - Reply